Yes, there is 15 teeth per each gear on the Replacement Gear Kit for etrailer and Ram Sidewind Jacks # TJA-2000S-GR. These gears have a thickness of 0.5", an OD of 1.36", and an ID of 0.5". view full answer...
The Dexstar Steel Spoke Trailer Wheel - 15" x 5" Rim - 5 on 4-1/2 - White Powder Coat # AM20422 will absolutely be able to accommodate the 65 psi needed when upgrading to a larger tire.
To do this, all you need is the Americana Rubber, Snap-In Valve Stem - 1-1/4" Long - Up to 65 psi # AM20903. view full answer...
Trailer makers rarely keep track of smaller items like vent parts used in fabrication of their trailers so finding the right replacement part is often just a matter of measuring, as you have done.
Since we do have this item in stock, Ventline Exterior Wall Vent for RV Range Hood # V2111-03, I went to our warehouse to measure it for you. I put key dimensions on the linked photo that I prepared for you, including hole spacing.
I have some additional information that I could not easily add... view full answer...
The Reese Steadi-Flex Weight Distribution (WD) System # RP66560 that you are currently using for towing your Jayco Jay Flight 28RLS is actually exactly what you want. This system has a tongue weight (TW) range of 600 lbs - 1,200 lbs so the 700 lbs lands inside that range.
Ideally you want the total tongue weight (TTW) of your towing setup to fall right in the middle of your WD system. You can find your TTW by adding the loaded TW of your trailer with the weight of any cargo behind the... view full answer...
The overall dimensions on the Rear View Safety Monitor Mount # RVS-Mount are 3.25" (H) x 4" (L) x 3.75" (D). So the base is about 3-3/4" x 4" and the arm is about 3-1/4". I attached a diagram below to show this better. This will fit most RVS monitors including 7" monitors. Let me know which model of monitor you have and I can check if this mount will fit. view full answer...
The Hickory Springs Manual Pull-Out Steps # 98224EXTALC1 referenced in your question feature a distance of 14.74 inches from the top of the mounting brackets to the bottom of the assembly when fully open. The mounting base has an overall width of 27.50 inches with a 9 inch drop/rise between the steps.
I have attached an image with these and other dimensions labeled for this particular assembly that you can check out as well. You can also use Outriggers like # LC301704 to install new brackets... view full answer...
When the Taylor Made Gas Shock part # 3691843-20 is compressed it is right at 12 inches long and when extended it is 20 inches long. view full answer...